“Characterisation and performance evaluation of TiSiN & TiAlSiN coatings by RF magnetron sputtering deposition during end milling of maraging steel” Materials Research Express (IOP Journal) (Under Review).
“Effect of Supply Frequency on Pre-breakdown and Breakdown Phenomena in Unbridged Vacuum Gaps” IEEE Transactions 2020 (Under review).
“Natural fruit sugars and human health: A reality”, Review Article, Journal of Advances in Nutrition and food sciences, 24th May 2019, ISSN; 2572-5971
“A Technique for Estimation of Residual Stress and Young’s Modulus of Compressively Stressed Thin Films Using Microfabricated Beams" for publication in IEEE Journal of Microelectromechanical Systems (Accepted for Publication-2019) DOI: 10.1109/JMEMS.2019.2948016.
“Critical investigation on Cu-O Bonding Configuration Variation in Copper-Oxide Thin Films for Low-Cost Solar Cell Applications” Materials Science in Semiconductor Processing 96 (2019) 127-131.
“Growth Temperature Influenced Electrical Properties of Copper-oxide Thin Films” AIP Proceedings 2105 (2019) 020007.
“Effect of annealing on the properties of Cu2SnS3 thin films using spin coating” AIP Proceedings 2105 (2019) 020001.
"Influence of vacuum annealing on the properties of Cu2SnS3 thin films using low cost ultrasonic spray pyrolysis", AIP Proceedings 1966 (2018) 020039
“Corrigendum to “Influence of silver nanoparticles on titanium oxide and nitrogen doped titanium oxide thin films for sun light photocatalysis” [Appl. Surf. Sci. 436 (2018) 708––719]” Applied Surface Science 440 (2018) 1299
“Local structure of amorphous Ag5In5Sb60Te30 and In3SbTe2 phase change materials revealed by X-ray photoelectron and Raman spectroscopic studies” Journal of Applied Physics 122(1):015305 · July 2017
“Surface-plasmon-induced photoabsorption of Ag nanoparticle embedded a-Si solar cell”, Optical Materials 73 (2017) 179-187
“Towards β-Phase formation probability in spin coated PVDF thin films” J. Polym Res (2017) 24: 35.
“Comparative Study on Capacitive Pressure Sensor for Structural Health Monitoring Applications”, International Journal of Innovative Research in Science, Engineering and Technology”, Vol. 6, Issue 5, May 2017
“Study of the Properties of the Porous Silicon Synthesized by Ag Assisted Electrolysis Etching” International Letters of Chemistry, Physics and Astronomy 71 (2016) 40-48
“Effect of post deposition annealing on the structure, morphology, optical and electrical properties of CuInGaSe2 thin films” Optical Materials 62 (2016) 132-138
"Phase dependent Ag loaded TiO2 films for photo-catalitic activity under sun light" Applied Surface Science 364 (2016) 732-739.
"Studies on RF magnetron sputtered HfO2 thin films for microelectronic Applications" Electron. Mater. Lett. 11 (2015) 592-600.
“Hydrogen Induced Mechanical Properties of Sputter Deposited Amorphous Silicon Thin Films” Materials Science in Semiconductor Processing 38 (2015) 165-170.
"On the Quality of Hydrogenated Amorphous Silicon Deposited by Sputtering" Materials Science in Semiconductor Processing, 26 (2014) 367–373.
“Effect of Post-deposition Annealing on the Composition and Electrical Properties of DC Reactive Magnetron Sputtered Al2O3 Thin Films” Materials Technology, 29 (2014) 83-89.
“Critical Investigation on Hydrogen Bonding by Fourier Transform Infrared spectroscopy in Hydrogenated Amorphous Silicon Thin Films” Journal of Non-Crystalline Solids 375 (2013) 88–94.
“Influence of Si–C Bond Density on the Properties of a-Si1–xCx Thin Films”, Applied Surface Science, 258 (2012) 2989-2996.
Microstructure Dependent Opto-Electronic Properties of Amorphous Hydrogenated Silicon Thin Films Materials Today: Proceedings Volume 5, Issue 1, Part 3, 2018, Pages 2527-2533
“Effect of plasma ion etching on Si nano wires towards superhydrophobicity” Materials Today: Proceedings 3 (6), 1907-1913 “Effect of Substrate Temperature on the Microstructure Variation in Sputter-deposited Hydrogenated Amorphous Silicon Thin Films” International Conference on Advanced Nanomaterials and Emerging Engineering Technologies (ICANMEET-2013); Chennai, July 24-26, 2013. IEEE Conference Proceedings (10.1109/ICANMEET.2013.6609345).
“Design and implementation of 4:2:2:4 Neural Network Architecture”, International Conference on Frontiers of Computer Science August 7- 9th 2011
ASIC Implementation of Random Perturbation Algorithm for Neural Network Architecture”; International Conference on Frontiers of Computer Science; August 7- 9th 2011
“Design and Implementation of a Neuron for Image compression and Decompression ,Ankura -11, National Institute of Engineering, Mysore April 20th 2011
“An ASIC Implementation of a Neuron”, 34th National Systems Conference, NITK Surathkal 10-12th December, 2010.
“A MEMS Condenser Microphone for consumer applications”, Comsol conference, November 2011.
“ASIC implementation of an MDAC circuit for Neural Network Application”, Anusandhana, Journal of science, Engineering and management, vol 01, Issue 1 2012.
Design and implementation of Gilbert cell multiplier”, Anusandhana, Journal of science, Engineering and management, vol 01, Issue 1 2012.
“ Design and characterization of MEMS Thermal Actuator”, International conference on “Devices, Circuits and systems”, Karunya Univeristy, Coimbatore, IEEE conference. March 2012
“Design and Analysis of MEMS Varactor”, National Conference on Smart Materials Structures and Systems, September 21- 22, Coimbatore, 2012.
“Design of MEMS based Polymer Microphone for Hearing Aid Application”, COMSOL Conference , November 2-3 2012
“Design and Simulation of Piezoelectric MEMS Microphone”, ISSS National Conference on MEMS, Smart Materials, Structures and Systems, September 06-07, 2013, Pune, India
“ Design and simulation of Silicon and Polymer based Piezoelectric MEMS Microphone”, International Conference on Emerging trends in communication, control, signal processing and computing applications, IEEE conference, 10th to 11th October 2013.
“Design and simulation of Polymer Piezoelectric MEMS Microphone”, International Conference on Circuits, Controls and Communication (CCUBE) IEEE conference, Dec 27-28 2013.
“Design and Simulation of MEMS Directional Microphone”, ISSS International conference, July 8-11th 2014.
“Design, Simulation and Comparison of two novel MEMS Directional Microphone using MUMPs Process”, Anusandhana Journal of Science, Engineering and Management, Vol 04, Issue 01, ISSN: 2231-4032, June 2015 pp 1- 15.
“Design and Simulation of MEMS Directional Microphone for Battle Damage Assessments”, IEEE proceedings is 15th IEEE International Conference on Nanotechnology, Rome Italy, 27th to 30th July 2015.
“ Piezoelectric Acoustic Sensor for Energy Harvesting”, International Journal of Innovative Research Science, Engineering and Technology, Vol.5, Special Issue 9, May 2016.
“Design and simulation of MEMS based acoustic sensor”, COMSOL conference 2016.
“Design and Simulation of PVDF based Piezoelectric Pressure Sensor using Thin Film Technology”, National conference on Information, communication, controls and computing, May 2017.
“Design and Simulation of MEMS microphone for hearing aid application”, National conference on Information, communication, controls and computing, May 2017.
“Design and Simulation of MEMS microphone for hearing aid application”, International Journal of Advance Electrical and Electronics Engineering (IJAEEE), ISSN (Print): 2278-8948, Volume-6 Issue-1_2, 2017.
“Capacitive pressure sensor for structural health monitoring applications”, ERCAM July 2017.
“Integration of Readout circuitry for MEMS Directional Microphone”,ERCAM July 2017
“Design, fabrication and characterization of a biologically inspired MEMS directional microphone”, has been accepted for publication at IEEE Sensor’s conference Oct 2018
“A Gm/ Id based methodology for designing common source amplifier” has been accepted for publication at IEEE ICMETE- Sept 2018